What Gets FixedDishwasher Problems the Pros in Our Network Handle
These are the calls our dispatchers take most often from homeowners around Fayette. Each symptom leads to a different group of parts, so a clear description on the phone helps the technician arrive prepared.
DrainageStanding Water and Won't Drain
Dirty water sitting in the bottom of the tub after a cycle is the most common call we route. The technician starts at the cheap end: the filter and chopper assembly, then the drain hose for kinks behind the unit, then the high loop or air gap under the sink. If those are clear, the drain pump and check valve come next.
- Clogged filter and chopper blade
- Drain pump impeller jammed by glass or a fruit pit
- Stuck check valve letting water flow back
- Garbage disposal knockout plug left in on a new install
LeaksLeaking Under the Cabinet or Onto the Floor
Water on a hardwood floor or wicking into the cabinet below is the call that comes in with real panic, and rightly so. The pro removes the kick plate and follows the drip with a flashlight and dry paper towels until the real source shows up. It might be the door gasket, a cracked sump, a loose inlet fitting, or a pump seal.
- Worn or torn door gasket
- Tub leaks at the sump or heater nuts
- Inlet valve fitting or supply line drip
- Wrong detergent causing suds to push out the door
WashingDishes Coming Out Dirty
If plates come out with food still stuck on, the water is usually not reaching them with enough force. The technician clears the spray arm jets, checks the spray arm bearings for wear, and listens to the circulation or wash motor while it runs. A weak motor often hums but moves little water.
- Blocked spray arm holes from seeds or labels
- Cracked or wobbling spray arm and bearing
- Circulation motor winding or capacitor tested with a meter
- Low fill from a weak inlet valve
FillingWon't Fill, Overfills or Keeps Filling
A dishwasher that sits silent at the start of a cycle, or one that floods the tub, usually comes down to the water inlet valve, its solenoid, or the float and float switch. The pro checks voltage at the valve and measures the solenoid coil with a multimeter. Overfill protection on many models will shut the cycle down and throw a code.
- Inlet valve solenoid open or valve stuck
- Float stuck down by debris
- Faulty float switch or overfill sensor
- Supply valve under the sink only partly open
Heating and DryingNot Heating or Dishes Still Wet
Cold rinse water and wet dishes point to the heating side of the machine. The technician tests the heating element for continuity, checks the thermistor reading against the tech sheet, and confirms the hi-limit and thermal fuse have not opened. Drying also depends on the rinse aid dispenser and, on some models, a vent fan.
- Burned-out heating element
- Thermistor out of spec
- Empty or broken rinse aid dispenser
- Vent fan motor failed on condensation-dry models
Controls and InstallError Codes, Latches and Installation
A blinking code, a door that will not latch, or a cycle that will not start can mean a failed door latch and switch or a control board fault. The pro reads the code from the service manual and wears an ESD strap before touching the board. The same pros handle new installs, leveling, panel-ready doors, drawer units and third-rack models.
- Door latch, door switch and detergent dispenser door latch
- Control board and user interface faults
- Leveling, anti-tip brackets and drain routing
- Panel-ready, drawer and third-rack models
